DMX 8/DMX 16
How To Talk Back To A Remote/How To Program The TB Button
Wheatstone IP Audio Consoles have a TB button for talkback. How does it work? 1. Route the microphone you want to use to the Talkback Mic destination for the console. It will look like this: You might be tempted to lock this destination so it doesn't ...
Understanding Console Default Crosspoint Mapping
Applies to: DMX, IP-12, IP-16, L-8, L-12, L-16 These are the internal system crosspoints that are set up by default when you first install your console. They create the necessary outputs for the program busses as well as the cue and headphone ...
Console Maintenance and Cleaning
Internal Maintenance The main accumulation of dust in a console will be found on the motherboard, which is mounted in the bottom of the console frame. You can use either a vacuum cleaner or compressed air, or a combination of these, to remove as much ...
How To Network DMX Consoles Together
Introduction While there is a small Ethernet switch built into the DMX Console Blade, it is primarily there to connect the console, blade, maybe a PC with a WheatNet-IP driver, and another blade in a studio, and this is how the switch is configured ...
Switching Studios With Momentary LIO/LED and Console Spare Buttons
The Spare Button LEDs on Wheatstone consoles can be turned on by various methods. By default, the surface itself turns a spare button's LED on when the button is pressed. But sometimes you want the LED to display some kind of status such as when you ...
Console Meters Scroll Continuously. Console Not Connected To Engine
Problem When the console is not connected to its engine, the meters scroll continuously and no text is displayed. Solution Connect to the console using the Console Setup GUI. Make sure that BOTH the blade ID and the blade IP address are correct. If ...
How To Set Up A Mic Tally Light
Key Concepts This article covers how to create a Mic Tally light for one microphone that is tied to that microphone being turned on and off. This would be applicable for a LED light mounted on a mic arm or some sort of tally indicator for a single ...
How To Set Up Remote Starts and Stops on a DMX Console
Key Concepts We will be editing the source in Navigator. In WheatNet-IP, the logic is associated with the source, not the fader. That way, when you move the source to a different fader, the logic follows wherever the source goes. When a source is ...
Audioarts DMX-8/DMX-16 Manual/How To Videos
DMX Console Quick Start Guide Download here DMX Mix Engine Quick Start Guide Download here How To Network a DMX Engine With A Wheatstone Blade System Download here How-To Videos
How To Set Up On-Air Lights and Mic Muting on a DMX
What You Will Need The DMX Console Ssetup GUI WheatNet Navigator Step 1 - Define The Mute Group in VDIPs Open the DMX Surface Setup program. This program does not automatically update the list of sources and destinations, so before we begin, do a ...