There are several source and destination signals that are generated when a surface is added to a Wheatstone Bridge Router system or SAT cage. These signals generally start at signal ID 1000 for both sources and destinations. What follows is a listing ...
I’m new, and my station has a Bridge Router. Can you give me an overview of how the system works? In a Wheatstone TDM system, anything with an IP address needs to have a unique address on a common subnet. The default TDM subnet is 192.168.1.0, but ...
Rather than seek out a new installer and install it on the new PC, we prefer to have the files copied from the old PC whenever possible. This assures that you are using a compatible version of XPoint, since in many cases installing a newer version of ...
Navigator 5, in concert with current Blade software, provides a plethora of new features helpful in administering and diagnosing the health of the Blades in your WheatNet-IP system at a glance. Diagnostics The Diagnostics tab gives you three graphs ...
The audio destinations for the IP12/IP16 front panel headphone jack and cue speaker need to be added after you connect the console to the mix engine blade. Here is how: 1. Add the console as a peripheral device in Navigator. Click the Devices tab in ...
Key Concepts We will be editing the source in Navigator. In WheatNet-IP, the logic is associated with the source, not the fader. That way, when you move the source to a different fader, the logic follows wherever the source goes. When a source is ...
Use Case You have contact closures coming into your system via relays from a satellite receiver. Your automation system does not have a device to connect the relays, but it does have the WheatNet-IP Audio Driver, which has Software LIOs to send and ...
Overview Let’s take a look at what needs to be done to get your Cisco 9200/9300 switch ready for the installation of your WheatNet‑IP system. Properly configuring your switch allows you to take advantage of the “management” capabilities to control ...