Everyone's first instinct when they get a new processor installed is to set the new one up exactly like the old one. We know how our voice is supposed to sound, and if we just turn the new knobs the same as the old ones, it's going to come out the ...
The FM and HD outputs and audio processing paths of a combination on-air processor differ in several ways: The FM side is pre-emphasized and peak limiting is done via distortion-cancelled clipping. The FM side also has the stereo multiplex generator ...
Navigator 5, in concert with current Blade software, provides a plethora of new features helpful in administering and diagnosing the health of the Blades in your WheatNet-IP system at a glance. Diagnostics The Diagnostics tab gives you three graphs ...
The audio destinations for the IP12/IP16 front panel headphone jack and cue speaker need to be added after you connect the console to the mix engine blade. Here is how: 1. Add the console as a peripheral device in Navigator. Click the Devices tab in ...
Key Concepts We will be editing the source in Navigator. In WheatNet-IP, the logic is associated with the source, not the fader. That way, when you move the source to a different fader, the logic follows wherever the source goes. When a source is ...
Use Case You have contact closures coming into your system via relays from a satellite receiver. Your automation system does not have a device to connect the relays, but it does have the WheatNet-IP Audio Driver, which has Software LIOs to send and ...
Overview Let’s take a look at what needs to be done to get your Cisco 9200/9300 switch ready for the installation of your WheatNet‑IP system. Properly configuring your switch allows you to take advantage of the “management” capabilities to control ...