Understanding the Navigator 5 Diagnostics Tab

Understanding the Navigator 5 Diagnostics Tab

The document attached to this article explains how to interpret the graphs on the Navigator 5 Diagnostics tab. The diagnostics are only available on Navigator 5. To obtain Navigator 5, reach out to Wheatstone Sales or your dealer.

    • Related Articles

    • Understanding Logic in Wheatnet-IP

      How to set up on air lights? Machine starts and stops? Tally lights? We'll explain how here. There are three rules that guide all logic in the WheatNet-IP system: 1. A WNIP source needs to connect to a WNIP destination. Think of the crosspoint grid ...

    • What's New in Navigator 5

      Navigator 5, in concert with current Blade software, provides a plethora of new features helpful in administering and diagnosing the health of the Blades in your WheatNet-IP system at a glance. Diagnostics The Diagnostics tab gives you three graphs ...

    • Slave Mode Checkbox in Navigator Blade Admin

      In most Navigator versions there is a checkbox on the Master Preference pane in the Blade Admin tab called "Slave Mode." There has been some confusion about when this checkbox should be used. Slave Mode is intended only for unique situations where ...

    • All Blades Appear Disconnected in Navigator/Navigator Sees No Blades But You Can Ping Them

      Problem: No blades show in Navigator. After a bit, you can click OK and the tabs appear, but there are no blades in the list. You can see them in locator but not in the system dock. Possibility #1: Navigator is looking at an old IP address. Go to the ...

    • Understanding inputs on the M4IP-USB Blade

      Question: I have an M-4 blade and am trying to use the USB inputs. When I connect my PC to the USB port, the computer finds the USB driver. And, when I play audio on the PC, I can see the audio on the Blade's front panel meters so I know that audio ...