TCP/UDP Ports and Multicast Info
UDP Ports
These ports must remain open for proper system operation.
Port
| Usage
| Details
|
50100
| Audio
| Default WNIP Audio Port
|
51000
| Metronome
| Clock synchronization, every 5 ms
|
52000
| Announce
| System control messaging
|
52001
| Logger
| Plain Text ASCII Logs
|
52002
| Meters
| Metering data encoded into meter structures
|
52003
| LIOs
| LIO messages
|
52008
| LIO Log
| LIO event log
|
53999
| Proxy Server Request
| MiniBlade to Master requests for a proxy blade
|
54001
| Proxy Server Reply
| Master to MiniBlade reply with a proxy blade
|
55555
| Locator
| Broadcast port used for locator pings and replies
|
TCP Ports
These ports must remain open for proper system operation
Port
| Usage
| Details
|
23000
| Telnet
| For blade debug interface
|
50000-50999
| Navigator
| 50000 base port + Blade ID
|
51002
| TCP Meters
| Metering data encoded in meter structures
|
54000
| Proxy Announce
| Razor/MiniBlade to proxy blade for relayed announce traffic
|
55776
| ACI
| Automation Control Interface for blades
|
55777
| ACI
| Automation Control Interface for Surfaces
|
56000-56999
| PR&E Navigator
| 56000 base port + blade ID (depreciated)
|
60000
| Surface
| Surface interface
|
60021
| Third Party Interface
| Third party/peripheral device control interface
|
Multicast Addresses
Address
| Usage
| Details
|
238.38.38.38
| Announce, Logger, LIO
| WNIP system control traffic
|
238.38.38.39
| Metering
| VU and other metering traffic
|
239.192.0.0
| Metronomes
| Sample Rate Clock synchronization
|
239.192.192.0
| Default Audio Base Multicast
| Audio data, default allocated addresses start here
|
224.0.1.129
| PTP Sync
| PTP messaging for AES67 clock synchronization
|
Related Articles
Multicast Overlap/Stream Manager Error
Multicast overlap is a condition that can occur when system changes are made in a way that doesn't allow Navigator and the Route Master blade to keep up with multicast ip address allocations. You end up with a "stream manager error" in Navigator and ...
Cisco 9300 Switch - Multicast is flooded when "no ip igmp snooping tcn flood" is in config
Background Wheatstone configures access and trunk ports on Cisco switches to use the "no ip igmp snooping tcn flood" command. This command tells the switch to disable the flooding of multicast traffic during a spanning-tree Topology Change ...
Diagnosing Multicast Exceptions in Blade v4.3.x
Blade Version 4.3.x performs a Multicast Exception Check and will engage an alarm in Navigator that appears in the Alarm Dock when it detects that two sources are using the same multicast IP address. When you see this alert in the Alarm Dock, you ...
Optimizing Windows for the WheatNet-IP AoIP Driver
Introduction Audio over IP (AoIP) is the transportation of digital audio via local or wide area networks using the Internet Protocol. Due to the very nature of ethernet, there are numerous obstacles to the efficient transport of audio (and video) ...
How To Set Up Telos VX with WheatNet-IP Using AES67
Prerequisites You will need: A Precision Timing Protocol (PTP) v2 clock source on your WNIP Local Area Network. Both the blades and the VoIP phone hybrid need to sync to this clock, and they do not generate it. There are numerous PTP clock generators ...