SSP-8 Smart Switch Documentation

All documentation for programming the SSP-8 panel (which is available as either a rackmount or built into a LX-24, LXE, GSX, or L8/12/16 console) is in the help file of the setup software. Select Help from the menu and it will explain everything about programming the panel.

There is not a separate manual for the software.

• Related Articles

• Windows Update Sample Rate Switch

  Windows updates can strike fear in the hearts of WheatNet-IP users that use our M4usb mic blades or our AoIP virtual audio drivers. If a new Windows audio driver component is installed with an update, it can reset the system sample rate of your audio ...

• Cisco 9300 Switch - Multicast is flooded when "no ip igmp snooping tcn flood" is in config

  Background Wheatstone configures access and trunk ports on Cisco switches to use the "no ip igmp snooping tcn flood" command. This command tells the switch to disable the flooding of multicast traffic during a spanning-tree Topology Change ...

• How To Add a SS-8 (SSP-8) Panel to the LXE, GSX, or LX-24

  Here's how to add an SS8 scriptable button panel to an LXE or GSX console. The jumpers and ribbon cable provide power and ethernet connectivity to the panel from the console. If you are installing the panel in an LX-24, you won't use the jumpers or ...

• DMX Mix Engine Rebooting/Falling off Network - Console scrolling meterbridge

  Symptom: Your DMX surface appears with meters scrolling or appears to be disconnecting from the network. You have looked in Navigator and you see the Mix Engine is showing up with a ? over it. You are losing audio and even after reboots are unable to ...

• Approved Ethernet Switches for WheatNet-IP

  Overview The Ethernet switch is the backbone of WheatNet-IP, as the network transports all of the audio between blades. Just as you selected Wheatstone because it is the best-in-class audio console, you need to select a best-in-class Ethernet switch ...