LIO-48 Logic Blade Manual

• Related Articles

• Understanding Logic in Wheatnet-IP

  How to set up on air lights? Machine starts and stops? Tally lights? We'll explain how here. There are three rules that guide all logic in the WheatNet-IP system: 1. A WNIP source needs to connect to a WNIP destination. Think of the crosspoint grid ...

• Wide Orbit WheatNet-IP Logic Setup

  These instruction sets apply to WideOrbit Automation for Radio versions 2.x to 3.7.x. Newer versions are likely similar. WideOrbit can address SLIO’s on blades via the Wheatnet ACI. For this setup you will need WO automation for Radio Device Server ...

• Wide Orbit WheatNet-IP Logic Setup

  These instruction sets apply to WideOrbit Automation for Radio versions 2.x to 3.7.x. Newer versions are likely similar. WideOrbit can address SLIO’s on blades via the Wheatnet ACI. For this setup you will need WO automation for Radio Device Server ...

• Understanding How Destinations Take Control of LIO Logic

  When you assign LIOs or SLIOs to a source, the control of that logic is determined by the first destination to lock the source. A destination locks when a console fader turns on or when you right-click a destination in Navigator and select Lock ...

• How To Map The Logic on a Microphone to a Talent Station

  Before You Begin IP Address Must Be Correct Have you set the IP address on the talent station to a valid address on your WheatNet-IP Network? They will all come set to the same default IP address, so if you plug in 8 talent stations and connect them ...