IP-16 Last 4 Faders Don't Work

IP-16 Last 4 Faders Don't Work

Problem

The last 4 faders do not show any text and none of the switches light up or work in this section.

Solution

You must tell the console that it is an IP16 for the main card to look at the last 4 faders.
  1. Open the IP Console Setup GUI and connect to the console
  2. Under Mix Inputs, change this to 16
  3. Click Apply.

    • Related Articles

    • Wide Orbit WheatNet-IP Logic Setup

      These instruction sets apply to WideOrbit Automation for Radio versions 2.x to 3.7.x. Newer versions are likely similar. WideOrbit can address SLIO’s on blades via the Wheatnet ACI. For this setup you will need WO automation for Radio Device Server ...

    • Wide Orbit WheatNet-IP Logic Setup

      These instruction sets apply to WideOrbit Automation for Radio versions 2.x to 3.7.x. Newer versions are likely similar. WideOrbit can address SLIO’s on blades via the Wheatnet ACI. For this setup you will need WO automation for Radio Device Server ...

    • Understanding Logic in Wheatnet-IP

      How to set up on air lights? Machine starts and stops? Tally lights? We'll explain how here. There are three rules that guide all logic in the WheatNet-IP system: 1. A WNIP source needs to connect to a WNIP destination. Think of the crosspoint grid ...

    • Configuring Paravel Systems WallTime with WheatNet-IP

      The Paravel Systems Walltime is a nice studio clock and notification system based on a Raspberry Pi. It can be used as your primary studio clock and can also display notifications from various systems, including Wheatnet-IP. As many of our customers ...

    • The Wheatnet-IP Meter App

      What is the Meter App? The IP Meters software for Wheatnet-IP gives you a fully customizable and nearly limitless display of meters from your Wheatnet system including but not limited to audio peak levels, average levels, signal density, FFT graphs, ...